Zeus User Manual

ZEUS-

Please fully charge your battery first. You can use your own 18650 charger for faster charging or the included USB cable. Plug in to a wall, car or power bank(no PC's). Remove silicone cover from top to reveal your nail (the threading is made of ceramic so try to be gentle when switching nails). Rinse then fill glass attachment with preferred water level before you place it on Zeus. Now press the button 3 times to turn on your device. After the welcome screen you will see your temperature blinking. Press the button to input your desired temp (750°F recommended for Titanium & Ceramic, 800°F for Quartz). Once your temp is displayed it will give you 5 seconds before starting the heat cycle. Remove the dab tool/carb cap and get your dab ready. When the button turns green wait 10 seconds then press 3 times to turn it off. Pre-heat cycle is complete. Press 3 times to turn it back on. You do not need to press anything just wait for the light to turn green again. Apply your dab then cover with carb cap and enjoy! Turn it off at any time by pressing 3 times. Pre-heat cycle should only be done once per session.

*Do not remove your heating rod. If you are having trouble with your device contact us. 

Pro-tips: 

-Titanium is the most battery efficient nail, but Quartz is the tastiest.

-Q-tip your nail after every session to keep your nail tasting delicious and save money on replacement nails.(smash q-tip first)

-Get an extra 18650 and Charger so you never run out of power (heavy users)

-Your nail will not heat up to the selected temp when the battery is running low. You can set the temp higher, recharge, or just switch to your spare 18650.

-Twist your glass on and off instead of pulling up or pushing down.